In:
Key Engineering Materials, Trans Tech Publications, Ltd., Vol. 326-328 ( 2006-12), p. 297-300
Kurzfassung:
Experimental investigation and numerical simulation on the effect of surface wettability
on the performance of a polydimethylsiloxane (PDMS) based diffuser micropump are presented. A valveless micro membrane pump with piezoelectric actuation has been examined. Using a replica
molding technique, the valveless micropump was made of PDMS on a Pyrex glass substrate. A thin piezoelectric (PZT) disc was used as an actuator. Poly vinyl alcohol (PVA) and
octadecyltrichlorosilane (OTS) coatings, which make the coated surface hydrophilic and hydrophobic, respectively, were used to modify the surface wettability inside the pump. In our
experiments, the contact angle of the PDMS surface changed from 96.6 o to 29.1 o and 99.6 o by PVA and OTS coatings, respectively, and the contact angle of glass changed from 33.2 o to 17.5 o
and 141.8 o. A self-priming process was numerically simulated in a diffuser element using a computational fluid dynamics program (CFD-ACE+). The results show that fewer gas bubbles were
created in the hydrophilic coated pump than in the hydrophobic coated one as time progressed. This agrees well with experimental observations. Steady-state flow rates of the micropump were
measured. Compared to the non-coated pump, the flow rate increased slightly with the hydrophobic coating but decreased with the hydrophilic coating. We determine that surface wettability
significantly affects the performance of a PDMS-based micropump.
Materialart:
Online-Ressource
ISSN:
1662-9795
DOI:
10.4028/www.scientific.net/KEM.326-328
DOI:
10.4028/www.scientific.net/KEM.326-328.297
Sprache:
Unbekannt
Verlag:
Trans Tech Publications, Ltd.
Publikationsdatum:
2006
ZDB Id:
2073306-9
Bookmarklink