Silicate glass and mineral dissolution: calculated reaction paths and activation energies for hydrolysis of a q3 si by H3O+ using ab initio methods

J Phys Chem A. 2006 Jan 12;110(1):198-206. doi: 10.1021/jp044360a.

Abstract

Molecular orbital energy minimizations were performed with the B3LYP/6-31G(d) method on a [((OH)3SiO)3SiOH-(H3O+).4(H2O)] cluster to follow the reaction path for hydrolysis of an Si-O-Si linkage via proton catalysis in a partially solvated system. The Q3 molecule was chosen (rather than Q2 or Q1) to estimate the maximum activation energy for a fully relaxed cluster representing the surface of an Al-depleted acid-etched alkali feldspar. Water molecules were included in the cluster to investigate the influence of explicit solvation on proton-transfer reactions and on the energy associated with hydroxylating the bridging oxygen atom (Obr). Single-point energy calculations were performed with the B3LYP/6-311+G(d,p) method. Proton transfer from the hydronium cation to an Obr requires sufficient energy to suggest that the Si-(OH)-Si species will occur only in trace quantities on a silica surface. Protonation of the Obr lengthens the Si-Obr bond and allows for the formation of a pentacoordinate Si intermediate ([5]Si). The energy required to form this species is the dominant component of the activation energy barrier to hydrolysis. After formation of the pentacoordinate intermediate, hydrolysis occurs via breaking the [5]Si-(OH)-Si linkage with a minimal activation energy barrier. A concerted mechanism involving stretching of the [5]Si-(OH) bond, proton transfer from the Si-(OH2)+ back to form H3O+, and a reversion of [5]Si to tetrahedral coordination was predicted. The activation energy for Q3Si hydrolysis calculated here was found to be less than that reported for Q3Si using a constrained cluster in the literature but significantly greater than the measured activation energies for the hydrolysis of Si-Obr bonds in silicate minerals. These results suggest that the rate-limiting step in silicate dissolution is not the hydrolysis of Q3Si-Obr bonds but rather the breakage of Q2 or Q1Si-Obr bonds.