In:
Advanced Materials, Wiley, Vol. 35, No. 31 ( 2023-08)
Kurzfassung:
The rapid development of highly integrated microelectronic devices causes urgent demands for advanced thermally conductive adhesives (TCAs) to solve the interfacial heat‐transfer issue. Due to their natural 2D structure and isotropic thermal conductivity, metal nanoflakes are promising fillers blended with polymer to develop high‐performance TCAs. However, achieving corresponding TCAs with thermal conductivity over 10 W m −1 K −1 at filler content below 30 vol% remains challenging so far. This longstanding bottleneck is mainly attributed to the fact that most current metal nanoflakes are prepared by “bottom‐up” processes (e.g., solution‐based chemical synthesis) and inevitably contain lattice defects or impurities, resulting in lower intrinsic thermal conductivities, only 20–65% of the theoretical value. Here, a “top‐down” strategy by splitting highly purified Ag foil with nanoscale thickness is adopted to prepare 2D Ag nanoflakes with an intrinsic thermal conductivity of 398.2 W m −1 K −1 , reaching 93% of the theoretical value. After directly blending with epoxy, the resultant Ag/epoxy exhibits a thermal conductivity of 15.1 W m −1 K −1 at low filler content of 18.6 vol%. Additionally, in practical microelectronic cooling performance evaluations, the interfacial heat‐transfer efficiency of the Ag/epoxy achieves ≈1.4 times that of the state‐of‐the‐art commercial TCA.
Materialart:
Online-Ressource
ISSN:
0935-9648
,
1521-4095
DOI:
10.1002/adma.202211100
Sprache:
Englisch
Verlag:
Wiley
Publikationsdatum:
2023
ZDB Id:
1474949-X
