In:
Meteoritics & Planetary Science, Wiley, Vol. 53, No. 6 ( 2018-06), p. 1164-1178
Abstract:
This study tested the feasibility of using 3‐D laser imaging to measure the bulk density of iron meteorites. 3‐D laser imaging is a technique in which a 3‐D model of an object is built after aligning and merging individual detailed images of its surface. Assuming that the mass of the object is known, the volume of the model is calculated by software and an estimate of bulk density can be obtained by dividing mass by volume. The 3‐D laser imaging technique was used to determine the density of 46 fragments from 11 different iron meteorites. The technique proved to be robust and was applied successfully to study samples ranging close to four orders of magnitude in mass (8 g to 156 kg) and exhibiting a variety of surface textures (e.g., cracks, regmaglypts), reflectivities (e.g., polished surfaces, fusion crust, rust), and morphologies (e.g., sharp angular edges, shrapnel tendrils). Three metrics were considered to estimate the error associated with density measurements: the range accuracy of the laser camera, image alignment error, and inter‐operator variability during model building. Inter‐operator variability was the largest source of error and was highest when assembling models of samples which either lacked distinctive features or were very complex in shape. Excluding two anomalous Zagora samples where silicate inclusions might have lowered density, the densities measured using 3‐D laser imaging ranged from 6.98 to 7.93 g cm −3 , consistent with previous studies. There is overlap between bulk density and iron meteorite class, and therefore bulk density cannot be used in isolation as a classification criterion. It is a good indicator, however, of weathering effects and of the potential presence of low‐density inclusions.
Type of Medium:
Online Resource
ISSN:
1086-9379
,
1945-5100
DOI:
10.1111/maps.2018.53.issue-6
Language:
English
Publisher:
Wiley
Publication Date:
2018
detail.hit.zdb_id:
2011097-2
SSG:
16,12
