In:
The International Archives of the Photogrammetry, Remote Sensing and Spatial Information Sciences, Copernicus GmbH, Vol. XXXVIII-3/W22 ( 2013-04-26), p. 173-178
Kurzfassung:
Abstract. In this work a simple new method for calibration evaluation and calibration stability monitoring of fringe projection based 3D scanners is introduced. This method is based on high precision point correspondence finding of fringe projection sensors using phase values in two perpendicular directions and epipolar geometry concerning calibration data of stereo sensors. The calibration evaluation method can be applied in the measurement process and does not require any additional effort or equipment. It allows the evaluation of the current set of calibration parameters and consideration of the stability of the current calibration over certain temporal progression. Additionally, the quality of distortion correction can be scored. The behavior of three fringe projection based 3D stereo scanner types was analyzed by experimental measurements. Results of the different types of scanners show that calibration may be stable over a long time period. On the other hand, suddenly occurring disturbances may be detected well. Additionally, the calibration error usually shows a significant drift in the warm-up phase until the operating temperature is achieved.
Materialart:
Online-Ressource
ISSN:
2194-9034
DOI:
10.5194/isprsarchives-XXXVIII-3-W22-173-2011
Sprache:
Englisch
Verlag:
Copernicus GmbH
Publikationsdatum:
2013
ZDB Id:
2874092-0